The above is our wood staircase manufacturers tell you to install a single beam finished staircase, wood staircase manufacturers now we tell you how to install necking finished stairs. (I) The skeleton of steel and wood staircase installation method: ① to re-check the height of the stairs, watching and drawing height is consistent, ② determine the stairs hanging and base position, L-shaped position ③ must also determine the details supporting the corner or wall support The necking keel parts placed on the ground, according to the paper size will dovetail with the drawing of the stairs keel, a press request sets a good, not fixed until the top wire and fro, ④ will set a good necking skeleton in accordance with drawings lifted into the installation location, drill fixed ⑤ skeleton level adjustment until after fixation screws (ii) the best wood stair treads installation method ① Remove the treads, stair treads to determine the installation location, and from to Under the gradual installation, there is little support even stepping little support height adjustment, then drill a small support and treads connection without fixed ② fixed first and then fixed treads little support, ③ step in accordance with the above manner, the final Tighten all screws fixed to steel and wood staircase fence (iii) installation method ① first column to determine the required installation position, drill column ② install fixed column base, loosen the top accessories, installation and drawing after drawing armrest ③ and handrails installed to adjust to the most suitable location, fixed all the screws above the fence post. Many stairs installation are similar, but there are a lot of different, we will give you one to explain, look forward to your attention. This article Source: wood staircase manufacturers, www.yixinlouti.com / www.yixinlouti.com/productlist/244_1.html